Home » News
  • (1) The short-circuit point is at the end. The shorts can be isolated with insulation, or the insulation can be rewrapped, painted and rebaked.(2) Short circuit in the wire slot. After softening it, find out the short-circuit point and repair it, put it back into the trunking, and then paint and dry
  • 1. Constant speed motor has common cage type, special cage type (deep groove type, double cage type, high starting torque type) and winding type.2. The speed control motor is equipped with a motor with a commutator. A three-phase parallel-excited wound rotor motor (rotor control resistor, rotor cont
  • (1) External observation method. Observe whether the junction box and the end of the winding are burnt. After the winding is overheated, it will leave dark brown and smell bad. (2) Temperature detection method. Run without load for 20 minutes (stop immediately if any abnormality is found), and use t
  • Faults:The motor does not work after energizing, and there is no abnormal sound, odor and smoke. Check the fault cause:1. Whether the power line is connected or not.2. Whether the insurance system burns out.3. Whether the current/voltage is adjusted too small.4. Whether the equipment connection is w
  • The three-phase asynchronous motor consists of two basic parts: a fixed stator and a rotating rotor. The rotor is installed in the inner cavity of the stator and supported on two end covers by means of bearings. 1. StatorThe stator is generally composed of three parts: the stator core, the stator wi
  • 1. End cap: support.2. Bearing: connect the rotating part and the stationary part.3. Bearing end cover: Protect the bearing.4. Fan: cooling motor.
Product diversification can better meet market demand.
 

CONTACT US

Copyright     2022 WENLING GOOD COMMERCE & TRADE CO.LTD.  浙ICP备2022029942号. Support By Leadong. Sitemap